|
|||||||
|
|
||
Fudia FSD700P series Industrial Grade 68-pin SCSI SSD uses an industry standard 2.5” SATA SSD (Solid State Disk) and converts it into a 3.5”50-pin Single Ended SCSI hard disk drive. It does not require any special software/device driver and is the ideal drop in replcements for legacy SCSI hard disk drives. |
||
 |
||
| Specifications | ||
| Flash Type | SLC | |
| Form Factor | 68 Pin 3.5 inch | |
| Support Capacity | 1 GB ~ 512 GB | |
| Interface | Convert SATA SSD to SCSI interface | |
| Support | Support a SATA hard drive of 1.5G/3.0G | |
| Support SCSI RAID card | ||
| Provides Flash ROM for firmware update | ||
| Jumper Setting | Selectable SCSI ID from 0 to 7 | |
| Delay Start | ||
| Write Protect | ||
| Parity Seeting | ||
| SCSI terminator | ||
| HDD Access LED | ||
| Features | Get the maximum benefits and high performance from SCSI Bus and SATA for devices | |
| Cost effective and higher system I/O performance | ||
| Creates new SCSI devices in economic cost | ||
| Designed in 3.5” form factor for a built-in 2.5” SATA hard disk drive | ||
| Supports full LVD/SE SCSI interface | ||
| Easy to install and use | ||
| Cross-platform operation supports Windows NT/2000/XP/2003/Vista, Linux, Mac, Sun | ||
| Transfer Rate | 320 MByte/sec (MAX) | |
| Operation Temperature | +5°C ~ +55°C | |
| Storage Temperature | -40°C ~ +70°C | |
| Vibration | 15 G (20 ~ 2,000 Hz) | |
| Humidity | 15% to 90% | |
| Shock | 1,000 G/0.5 ms |
|
| Power supply | DC 5V ± 5% | |
| Size: | 14.6cm (L) x 10.1cm (W) x 2.5cm (H) | |
| Country Of Origin | made in Taiwan | |
| Certificates Acquired | RoHS \ CE \ FCC | |
| Remarks | ||
/D1-3(TWN68).png)
