|
|||||||
|
 /D1-4(TWN80).png) |
|
Fudia FSD700P series Industrial Grade 80-pin SCSI SSD uses an industry standard 2.5” SATA SSD (Solid State Disk) and converts it into a 3.5”50-pin Single Ended SCSI hard disk drive. It does not require any special software/device driver and is the ideal drop in replcements for legacy SCSI hard disk drives. |
|
 |
|
| Specifications | |
| Flash Type | SLC |
| Form Factor | 80 Pin 3.5 inch |
| Support Capacity | 1 GB ~ 512 GB |
| Interface | Convert SATA SSD to SCSI interface |
| Support | Support a SATA hard drive of 1.5G/3.0G |
| Support SCSI RAID card | |
| Provides Flash ROM for firmware update | |
| Jumper Setting | Selectable SCSI ID from 0 to 7 |
| Delay Start | |
| Write Protect | |
| Parity Seeting | |
| SCSI terminator | |
| HDD Access LED | |
| Features | Get the maximum benefits and high performance from SCSI Bus and SATA for devices |
| Creates new SCSI devices in economic cost | |
| DCost effective and higher system I/O performanceesigned in 3.5” form factor for a built-in 2.5” SATA hard disk drive | |
| Supports full LVD/SE SCSI interface | |
| Easy to install and use | |
| Cross-platform operation supports Windows NT/2000/XP/2003/Vista, Linux, Mac, Sun | |
| Transfer Rate | 320 MByte/sec (MAX) |
| Operation Temperature | 0°C ~ +85°C |
| Storage Temperature | -40°C ~ +85°C |
| Vibration | 15 G (20 ~ 2,000 Hz) |
| Humidity | 15% to 90% |
| Shock | 1,000 G/0.5 ms |
| Power supply | DC 5V ± 5% |
| Size: | 14.6cm (L) x 10.1cm (W) x 2.5cm (H) |
| Country Of Origin | Made in Taiwan |
| Certificates Acquired | RoHS \ CE \ FCC |
| Remarks | |
